NB1601-LWWtSc-G
Der NB1601 LTE & WLAN kombiniert Mobilfunkrouter und WLAN in einem Gerät. Vier Ethernetports, digitale I/O, seriellen Schnittstellen, GNSS und ein Steckplatz für Erweiterungen ermöglichen Anwendungen wie Condition Monitoring oder Telemetrie.
Die überarbeitete Version des bewährten NB1600 besticht durch seine geänderte Kabelführung und bringt nun Raumgewinne in engen Schaltschränken.
Die überarbeitete Version des bewährten NB1600 besticht durch seine geänderte Kabelführung und bringt nun Raumgewinne in engen Schaltschränken.
|
Funktechnologie
Schnittstellen
Protokolle
Gehäuse
|
Besonderheit
Zulassung
|
 |
Datenblatt_NetModule_NB1601 LTE WIFI |
Zubehörkatalog
|
NetModule Zubehörkatalog |
Router Software
|
NetModule Router Software (NRSW) |
ConnectivitySuite
|
NetModule Connectivity Suite |
Extension Module
Wireless Module
| RS-232 Order Code: Sb |
RS-232 serial interface on miniPCIe card Signals: TX, RX, CTS, RTS Signal level: High > 5V / Low < -5V Bit rates: 600, 1200, 2400, 4800, 9600, 14400 (not supported by the Linux stty), 19200, 38400, 57600, 115200, 230400, 460800, 921600 bits/s Parity: None/Even/Odd Connection: Extension connector |
| RS-485 Order Code: Sa |
RS-485 serial interface on miniPCIe card Signals: RS485A, RS485B Signal level: Differential Output Voltage, Loaded 1.5V – 3.6V Bit rate: 600, 1200, 2400, 4800, 9600, 14400 (not supported by the Linux stty), 19200, 38400, 57600, 115200, 230400, 460800 bit/s Parity: None/Even/Odd Connection: Extension connector |
| CAN Order Code: C |
CAN interfaces on miniPCIe card Protocol: CAN V2.0B Signals: CANH, CANL, GND Signal level: High > 2.75V / Low < 2V Bit rate: Up to 1Mbps Galvanic isolation 1500 VDC; no internal bus termination Connection: Extension connector |
| COM/IO Order Code: Sc |
Serial and DIO Shield for standard interfaces: Protocols: RS-232 (RXD, TXD) or RS-485 (D+, D-) configurable Bit Rates: up to 1Mbps; RS-485 bus termination: 120R (configurable) 1 DI: level 0 (0-3VDC), level 1 (9-36VDC), isolation: 1500VAC 1 DO: 0-36VDC/1A; isolation: 1500VAC Extension connector: 6-8 pin terminal block, 3.5 mm pitch |
| Dual-CAN Order Code: 2C |
2xCAN Shield (not isolated) Bit rates: up to 1Mbps; bus termination: 120Ohms (configurable) Extension connector: 6 to 8 pin terminal block, 3.5 mm pitch |
| Audio Order Code: A |
Audio interface on a miniPCIe card In: level (0dB corresponds to 721mVRMS @ 1kHz) / impedance 36kΩ @ 1kHz Out: max. level -1.5dBu (0.65 VRMS, unloaded) / output level software controllable / impedance 375 Ω @ 1kHz Connection: Extension connector |
| Mass Storage Oder Code: D[a,b,c,d,e,f] |
Internal data storage extension 32 GB / 64 GB on miniPCIe card 128 GB / 256 GB / 512 GB / 1 TB on SSD |
| IBIS Order Code: I |
IBIS interface on a miniPCIe card IBIS Peripheral Device according to VDV 300 (Slave) Signals: WBED, WBME, WBSD, WBMS Bit: 1200 bit/s Galvanic isolation: 1500 VDC Connection: Extension connector |
| Isolated Digital IOs Order Code: D (coming) |
Isolated Digital Input/Output on a Extension Module Digital Lines: 2x in, 2x out (isolated) Digital Input Spec: level 0 (0-3VDC), level 1 (9-60VDC), isolation: 2000VAC Digital Output Spec: 0-60VDC/1A; isolation: 1500VAC Connection: Extension connector |
| PTT Order Code: Ap (samples available) |
Push-to-Talk module providing interfaces for driver communication on a miniPCIe card Audio Lines: 1x in, 1x out (both isolated) Audio Bandwidth: input 100 Hz – 15 kHz; output: 300 Hz – 4 kHz Digital Lines: 1x in, 1x out (both isolated) Digital Input Spec: level 0 (0-3VDC), level 1 (9-60VDC), isolation: 1000VAC Digital Output Spec: 0-60VDC/1A; isolation: 1000VAC Connection: Extension connector |
| FXS Oder Code: Fx (coming) |
The FXS analog telephony extension module provides dial tone, battery current, ring voltage to the subscriber phones (POTS). Function: POTS to VoIP or GSM/UMTS gateway Calls: incoming, outgoing; 1 line DMTF: tone generation and decoding Connector: RJ11 (Format POTS) Ringer Equivalence Number: up to 0.7 REN Max Cable Length: 30m |
Wireless Module
| LTE Cat 4 Region: EMEA Order Code: L |
Multimode LTE, UMTS and GSM module for EMEA 4G – LTE (FDD): B1, B3, B5, B7, B8, B20 3G - DC-HSPA+/UMTS: B1, B2, B5, B8 2G - GSM/GPRS/EDGE: B2, B3, B5, B8 LTE Specification: LTE Cat 4, 2x2 MIMO Data rates down/up (max): 150 Mbps / 50 Mbps Voice: CSFB Model: u-blox TOBY-L210 |
| LTE Cat 4 Region: APAC Order Code: Lg |
Multimode LTE, UMTS and GSM module for APAC 4G – LTE (FDD): B1, B3, B5, B7, B8, B28 3G - DC-HSPA+/UMTS: B1, B2, B5, B8 2G - GSM/GPRS/EDGE: B2, B3, B5, B8 LTE Specification: LTE Cat 4, 2x2 MIMO Data rates down/up (max): 150 Mbps / 50 Mbps Voice: CSFB Model: u-blox TOBY-L280 |
| LTE Cat 4 Region: NA Order Code: Lbb |
Multimode LTE and UMTS module for NA 4G – LTE (FDD): B2, B4, B5, B7, B17 3G - DC-HSPA+/UMTS: B1, B2, B4, B5, B8 2G - GSM/GPRS/EDGE: B2, B3, B5, B8 LTE Specification: LTE Cat 4, 2x2 MIMO Data rates down/up (max): 150 Mbps / 50 Mbps Voice: CSFB Model: u-blox TOBY-L200 |
| LTE Advanced Cat 6 Region: EMEA, NA Order Code: Ld |
Multimode LTE Advanced, UMTS module for EMEA, NA 4G – LTE (FDD): B1, B2, B3, B4, B5, B7, B8, B12, B13, B20, B25, B26, B29, B30, B41 3G - DC-HSPA+/UMTS: B1, B2, B3, B4, B5, B8 2G - GSM/GPRS/EDGE: none LTE Specification: LTE Cat 6, 2x2 MIMO Data rates down/up (max): 300 Mbps / 50 Mbps Voice: none Model: Sierra Wireless MC7455 |
| LTE Advanced Cat 6 Region: APAC Order Code: Lc |
Multimode LTE Advanced, UMTS module for APAC 4G – LTE (FDD) B1, B3, B5, B7, B8, B18, B19, B21, B28, B38, B39, B40, B41 3G - DC-HSPA+/UMTS B1, B5, B6, B8, B9, B19 2G - GSM/GPRS/EDGE none LTE Specification LTE Cat 6, 2x2 MIMO Data rates down/up (max) 300 Mbps / 50 Mbps Voice none Model: Sierra Wireless MC7430 |
| LTE450 Cat 3 Order Code: La |
LTE Modem for 450MHz 4G – LTE (FDD): B3, B7, B20, B31(450) 3G - DC-HSPA+/UMTS: B1, B8 2G - GSM/GPRS/EDGE: 900, 1800 LTE Specification: LTE Cat 3, 2x2 MIMO Data rates down/up (max): 100 Mbps / 50 Mbps Voice: none |
| GSM-R Order Code: Gr |
GSM-R module for EMEA 2G - GSM-R/GPRS/EDGE: GSM-R/EGSM900, GSM1800 Data service: GPRS class 10 Data rates down/up (max): 85.6/42.8 kbps Voice: none (on request) |
| WLAN-ac Order Code: Wac |
Wireless miniPCIe card IEEE 802.11 a/b/g/n/ac up to 867 Mbps 2.4/5GHz 2x2 MIMO, Access Point or Client Clients in access point mode: at least 100, no limitation by software |
| GNSS Advanced Order Code: Ga |
Advance GNSS receiver on a miniPCIe card GPS / GLONASS / BeiDou / Galileo; 72-channel u-blox M8 engine; Sensitivity –160 dBm, 72-channel; 2m accuracy; |
| GNSS-Udr Order Code: Gd |
GNSS receiver with Dead Reckoning on a miniPCIe card GPS / GLONASS / BeiDou / Galileo; 72-channel u-blox M8 engine; Sensitivity –160 dBm, 72-channel; 2m accuracy; Onboard accelerometer and gyroscope for untethered dead reckoning |